Toyota Camry Maintenance Light
By
Herman Syah
—
Thursday, March 15, 2018
—
Reset Maintenance Light Toyota Camry
Toyota Camry Maintenance Light
How to reset maintenance needed light on 2004-2015 Toyota Camry:
2007-2015
-With car ignition switched over to ON position, see to it odometer is revealing "Tripmeter A", then transform the ignition button to OFF position
-Push and hold the TRIP reset or SETTING button
-While holding reset switch, switch ignition to ON placement
** w/ ENGINE START/STOP switch, keep your foot off brake pedal and push ENGINE START/STOP switch twice to obtain Key On/ Engine Off setting
-Continue to hold the reset switch until the odometer presents "000000" and after that the initial worth is shown
-Transform the vehicle off and also back on to confirm reset was approved
2010-2015
-On the navigation display, press ARRANGEMENT
-After that press LORRY, after that MAINTENANCE
-Touch the wanted item where you need to reset (i.e. Engine Oil, Oil Filter, Tire Rotation, and so on).
-From here, fill in the requested fields with the new "Next Service" interval (i.e. day and range till following solution is due).
-Press OK when full.
-Repeat actions 3-5 for any other services that were carried out.
2004-2006
-With vehicle ignition switched over to ON position, make certain odometer analysis is shown, after that turn the ignition button to OFF position.
-While holding reset switch, switch ignition to ON placement.
** w/ ENGINE START/STOP button, keep your foot off brake pedal and press ENGINE START/STOP button twice to obtain Key On/ Engine Off mode.
-Continuously hold the reset switch until the odometer presents "000000" and/or the MAINT REQD light goes off.
-Turn the automobile off as well as back on confirm reset was accepted.
2004-2009
-On the navigation display, press INFORMATION or SETUP.
-After that touch UPKEEP.
-Touch the wanted thing in which you need to reset (i.e. Engine Oil, Oil Filter, Tire Rotation, etc.).
-From here, fill in the asked for fields with the brand-new "Next Solution" period (i.e. date next solution due and/or distance till following service is due).
-Press OK when total.
-Repeat actions 3-5 for other services that were done.
We wish you find these reset procedures helpful.